Workflow · Stand
How to Save Stand Parameters
When configuring global Stand module parameters such as default entities, conditions, and settings. Covers the Guardar button on the parameters form.
Evidence Summary
| Module | Stand |
|---|
| Route | /stand/apoio/parametros |
|---|
| Run | crion-stand-parametros-20260606T163401Z |
|---|
| Steps | 9 (9 ok) |
|---|
| Backend calls | 0 |
|---|
| Evidence JSON | raw/playwright/workflows/crion-stand-parametros-20260606T163401Z.json |
|---|
Step-by-Step
- Open Stand Parametros page — ok
- Wait for parameters form save button — ok
- Screenshot of parameters form — ok
- Click Guardar to save parameters (no changes needed — idempotent save) — ok
- Screenshot after parameters saved — ok
- Open Stand Parametros page — ok
- Wait for save button — ok
- Assert save button is present — ok
- Screenshot confirming page loaded — ok
Verification
- Assert save button is present: ✅ Guardar
Edge Cases Covered
- Verify parameters page loads correctly and form is accessible
Screenshots
parametros-form
after-parametros-saved
edge-parametros-load-check
edge-Verify parameters page loads correctly and form is accessible